What does F2 mean on Dacor oven?

Published by Anaya Cole on

What does F2 mean on Dacor oven?

Heating Mode High Temperature
F2 – Heating Mode High Temperature – This error will occur when the control board (clock) senses a runaway heat condition or when the temperature exceeds runaway limits. This error, along with a beeping, will continue until ‘cancel’ is selected.

What does F1 mean on Dacor oven?

If the Membrane is faulty, the F1 will cease, then replace the membrane. For Continuing F1. After the above is completed follow the steps below. Inspect the Molex plug connection from the ERC to to the relay board for a shorted connection. Check relay board for cracked solder joints at the connection.

How do I change the control board on my Dacor range?

Here’s a step-by-step guide on how to replace Dacor oven relay board:

  1. Step 1: Shut Off Power and Gas Supply.
  2. Step 2: Remove Lower Back Panel.
  3. Step 3: Detach the Relay Control Board.
  4. Step 4: Remove the Relay Control Board.
  5. Step 5: Mount the New Relay Control Board.
  6. Step 6: Connect the Cables.
  7. Step 7: Reattach the Back Panel.

Is there a way to reset your oven?

Turn the circuit breaker to the OFF position or remove the fuse. Wait one minute, then turn the circuit breaker back to the ON position or install the fuse to reset power to the unit. This should reset the electronic controls on the range or wall oven.

Why is my stove beeping F2?

In this case, the F2 error code indicates that the oven temperature is too high. Now, this does not necessarily mean that the temperature inside the oven really is too high. The oven control board (clock) is responsible for measuring the resistance of the sensor circuit.

How do I stop F1 error on my oven?

To stop the flashing and beeping, press the “Cancel” button to stop the beeping and clear the error code. Try the bake or broil feature once more, and if the error code repeats, unplug the appliance and wait five minutes before plugging it back in.

How do you reset a beeping oven?

To reset your oven, unplug it from the power and leave it unplugged for at least 30 seconds. If the beeping resumes after the oven is plugged back in, it will be necessary to determine the cause of the error code.